For speedtouch 510
 

If you want too host with a speedtouch you need too open the poorts with this program still you can't stay in servers.

Save as


Poorts

10052 UDP and TCP
10053 UDP and TCP
10054 UDP and TCP

I used the program from http://www.speedtouch.nl/downloads/NAT_manager_01.exe, but both seem to work - my URL points to an oficially supported site though, so that one will probably stay up longer.. Be sure there is no other device (such as a router) between your PC and your modem when using this, or it won't work.
Too bad joining games is still impossible.

Found something but its dutch

http://gathering.tweakers.net/forum/...ssages/1057783

I was wondering, in the NAPT setup, what should I specify as inside address? My network address (192.168.1.102), my "internet" address (62.251.111.252) or my modem's setup IP address (10.0.0.138), or even something else?

By the way, new firmware is available here - a configurator for it is hosted here.

guess special IP for the host and modem, but not sure

Your inside address is the address of the computer you want to use to play JJ2. To find out this address, under Windows 95/98/ME run winipcfg.exe. Under Windows NT/2000/XP/2003 run cmd.exe, and then type "ipconfig" and press enter in the window that appears.

I had already oppened the ports mannualy, because off that, i can now only host at jj2, which i coudnt before. Its still recommended to do, i suggest you to use www.portforward.com iff you need/want, because other games like UT and WC3 now work perfectly again for me ( both hosting and joining ).

Still i'm trying too fixing the joining problem(s), who has some suggestions?